You could use one of the Ender 3 versions with the Meanwell PSU, but it would be blowing down instead of to the back of the printer. I also added versions for the Meanwell power supply where the shroud is mirrored on the Y-Axis, as well as V2 versions with no adornments for both PSUs. Please let me know if the screw holes still aren't short enough in the V2 versions. Pick one of the V2 versions to print unless you have a good reason for doing otherwise. I left the original versions but there should be no reason to use them, although it's possible that they are better at silencing the noise. You probably can do this by hand by just twisting a 3/16" drill bit between your fingers.Ģ) Pivot the shroud out of the way and remove the second screw.ģ) Pivot the shroud in place and secure it with the second screw.Īdded V2 versions which are 1.5 mm shorter to accommodate newer versions of the PSU which have shorter screws. You may have to drill the holes to be a bit larger, so make sure the screw fits through both holes before attaching the shroud. IMPORTANT: Never have both screws removed at the same time or the fan will drop into the power supply case.ġ) Remove one screw and attach the shroud with it. This seems to be a perfect fit for the Ender 3 PSU, but you should scale the model up to 101.5% for the Ender 3 Pro PSU. The distance between the screw holes is 69.65 mm for all versions of the model. There are versions for the Ender 3 and for the Ender 3 Pro with the Meanwell PSU. There are embossed and debossed versions with the Ender 3 logo and with just the Ender 3 dragon. They attach using the original screws that mount the fan to the inside of the power supply case. These are fan silencer shrouds for the Ender 3 and Ender 3 Pro power supply fans.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |